Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-335
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show tacacs+
show tacacs+
To display the TACACS+ Cisco Fabric Services (CFS) distribution status and other details, use the show
tacacs+ command.
show tacacs+ {distribution status | pending | pending-diff}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines To use this command, TACACS+ must be enabled using the tacacs+ enable command.
Examples The following example shows how to display the TACACS+ distribution status.
switch# show tacacs+ distribution status
session ongoing: no
session db: does not exist
merge protocol status: merge activation done
last operation: none
last operation status: none
Related Commands
distribution status Displays the status of the TACACS+ CFS distribution.
pending Displays the pending configuration that is not yet applied.
pending-diff Displays the difference between the active configuration and the pending
configuration.
Release Modification
2.0(x) This command was introduced.
Command Description
tacacs+ enable Enables TACACS+.
tacacs+ distribute Initiates TACACS+ configuration distribution.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available