Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
8-79
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fspf hello-interval
fspf hello-interval
To verify the health of the link, use the fspf hello-interval command. To revert to the default value, use
the no form of the command.
fspf hello-interval seconds vsan vsan-id
no fspf hello-interval seconds vsan vsan-id
Syntax Description
Defaults 20 seconds
Command Modes Interface configuration submode.
Command History
Usage Guidelines Access this command from the
switch(config-if)# submode.
This command configures FSPF for the specified FCIP interface.
Note This value must be the same in the ports at both ends of the ISL.
Examples The following example configures a hello interval of 3 seconds on VSAN 1.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# fspf hello-interval 3 vsan 1
Related Commands
hello-interval seconds Specifies the FSPF hello-interval in seconds. The rage is 2 to 65535.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
Release Modification
1.1(1) This command was introduced.
Command Description
show fspf interface Displays information for each selected interface.
show interface fcip Displays an interface configuration for a specified FCIP interface.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available