Send documentation comments to mdsfeedback-doc@cisco.com
22-369
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show zone analysis
show zone analysis
To display detailed analysis and statistical information about the zoning database, use the show zone
analysis command.
show zone analysis {active vsan vsan-id | vsan vsan-id | zoneset name vsan vsan-id} |
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays detailed statistics and analysis of the active zoning database.
switch# show zone analysis active vsan 1
Zoning database analysis vsan 1
Active zoneset : zs1 [* | -]
Activated at: 14:36:56 UTC Oct 04 2005
Activated From: Local [CLI / SNMP / GS / CIM / INTERNAL] or
Merge [interface] or
Remote [Domain, IP-Address]
[Switch name]
Default zone policy: permit/deny
Number of devices zoned in vsan: 8/10 (Unzoned: 2 | Default-zone: #)
Number of zone members resolved: 11/16 (Unresolved: 5)
Num zones: 1
Number of IVR zones: 2
Number of IPS zones: 3
Formatted database size: < 1 Kb / 2000 kb ( < 1% usage)
Table 22-12 describes the fields displayed in the output of a show zone analysis command for the active
zoning database.
active Displays analysis information for the active zone set.
vsan vsan-id Displays analysis information for the specified VSAN ID. The range is 1 to
4093.
zoneset name Displays zone set analysis information for the specified zone set.
Release Modification
3.0(1) This command was introduced.
To Next Page
Loading...
Need help?
General
