Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-105
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
system trace
system trace
To configure the system trace level, use the system trace command in configuration mode. To disable
this feature, use the no form of the command.
system trace bit-mask
no system trace
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines This command is used for debugging purposes.
Examples The following example shows how to configure the system trace level.
switch# config terminal
switch(config)# system trace 0xff
bit-mask Specifies the bit mask to change the trace level.
Release Modification
1.0(2) This command was introduced.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available