Send documentation comments to mdsfeedback-doc@cisco.com
11-28
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface fcip
Defaults Disabled
Command Modes Configuration mode
Command History
Usage Guidelines You can specify a range of interfaces by issuing a command with the following example format:
interface fcip1space-space5space,spacefcip10space-space12space
Refer to the Cisco MDS 9000 Family CLI Configuration Guide for information on port number
allocation.
ficon Configures FICON parameters.
portnumber portnumber Configures the FICON port number for this interface.
hello-interval seconds Specifies FSPF hello-interval in seconds. The range is 1 to 65535.
passive Enables or disables FSPF on the interface.
retransmit-interval Specifies FSPF retransmit interface in seconds. The range is 1 to
65535.
passive-mode Configures a passive connection.
peer-info Configures the peer information.
ipaddr ip-address Specifies the peer IP address.
port number Specifies the peer port number. The range is 1 to 65535.
qos
Configures the differentiated services code point (DSCP) value to
mark all IP packets.
control control-value Specifies the control value for DSCP.
data data-value Specifies the data value for DSCP.
special-frame Configures special frames.
peer-wwn pwwn-id Specifies the peer WWN for special frames.
switchport Configures switchport parameters.
tcp-connections number Specifies the number of TCP connection attempts. Valid values are 1
or 2.
time-stamp Configures time-stamp.
acceptable-diff number Specifies the acceptable time difference for time-stamps. The range is
1 to 60000.
use-profile profile-id Specifies the interface using an existing profile ID. The range is 1 to
255.
Release Modification
1.1(1) This command was introduced.
1.3(1) Added the ficon portnumber subcommand.
2.0(x) Added the qos subcommand.
To Next Page
Loading...
Need help?
General
