EasyManuals Logo

Cisco MDS 9000 Series Command Reference

Cisco MDS 9000 Series
1464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
Send documentation comments to mdsfeedback-doc@cisco.com
3-5
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 3 B Commands
boot
When the boot auto-copy command is issued, the system copies the boot variable images which are local
(present) in the active supervisor module (but not in the standby supervisor module) to the standby
supervisor module. For kickstart and system boot variables, only those images that are set for the standby
supervisor module are copied. For modules (line card) images, all modules present in standby's
corresponding locations (bootflash: or slot0:) will be copied.
Examples The following example adds the new system image file to the SYSTEM environment variable.
switch(config)# boot system bootflash:system.img
The following example boots from the CompactFlash device (slot0:). The switch updates the SYSTEM
environment variable to reflect the new image file in the specified Flash device.
switch(config)# boot system slot0:system.img
The following example overwrites the old Kickstart environment variable in the configuration file:
switch(config)# boot kickstart bootflash:kickstart.img
The following example specifies the SSM image to be used:
switch(config)# boot asm-sfn bootflash:m9000-ek9-asm-sfn-mz.1.2.2.bin
The following example enables automatic copying of boot variables from the active supervisor module
to the standby supervisor module.
switch(config)# boot auto-copy
The following example disables the automatic copy feature (default).
switch(config)# no boot auto-copy
Related Commands Command Description
show boot Displays the configured boot variable information.

Table of Contents

Other manuals for Cisco MDS 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
CategorySwitch
Operating SystemCisco NX-OS
PortsVaries by model
ProtocolsFibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
RedundancyRedundant supervisors, power supplies, and fans
ManagementCisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization SupportVSANs (Virtual SANs)
Security FeaturesFibre Channel Security Protocol (FC-SP)
Hot Swappable Componentspower supplies, fans
Power Supply OptionsAC and DC options available

Related product manuals