Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
4-15
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
cfs ipv6 distribute
The following example shows how to reenable CFS IPv6 distribution.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# cfs ipv6 distribute
Related Commands Command Description
cfs ipv6 mcast-address Configures an IPv6 multicast address for Cisco Fabric Services (CFS)
distribution over IPv6.
show cfs status Displays whether CFS distribution is enabled or disabled.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available