Cisco MDS 9000 Series

Send documentation comments to mdsfeedback-doc@cisco.com
5-34
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 5 D Commands
do
The following example create, enables, and displays the interface from configuration mode.
switch(config)# int fc 3/1
switch(config-if)# no shut
switch(config-if)# do show interface fc 3/1
fc3/1 is trunking
Hardware is Fibre Channel
Port WWN is 20:81:00:05:32:00:4a:9e
Peer port WWN is 20:43:00:0c:88:00:4a:e2
Admin port mode is auto, trunk mode is on
Port mode is TE
Port vsan is 1
Speed is 2 Gbps
Transmit B2B Credit is 0
Receive B2B Credit is 255
Receive data field Size is 2112
Beacon is turned off
Trunk vsans (admin allowed and active) (1-10)
Trunk vsans (up) (1-10)
Trunk vsans (isolated) ()
Trunk vsans (initializing) ()
5 minutes input rate 504 bits/sec, 63 bytes/sec, 0 frames/sec
5 minutes output rate 344 bits/sec, 43 bytes/sec, 0 frames/sec
69390 frames input, 4458680 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
0 too long, 0 too short
69458 frames output, 3086812 bytes
0 discards, 0 errors
2 input OLS, 1 LRR, 0 NOS, 2 loop inits
1 output OLS, 1 LRR, 1 NOS, 1 loop inits