Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
6-67
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug ips
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug ips show_all command is issued:
switch# debug ips show_all
IPS Manager:
iSCSI Trace Detail debugging is on
Related Commands
vrrp Enables debugging of iSLB VRRP.
config Enables debugging of the iSNS configuration.
config-detail Enables detailed debugging of the iSNS configuration.
error Enables debugging of iSNS error conditions.
flow Enables debugging for the iSNS flow.
flow-detail Enables detailed debugging for the iSNS flow.
msgs Enables debugging of the iSNS messages received and responded.
packet Enables debugging of an iSNS packet.
show_all Enables all debugging IPS manager flags.
upgrade Enables debugging for upgrade.
Release Modification
1.1(1) This command was introduced.
3.0(1) Added the iSLB and iSNS options.
Command Description
no debug all Disables all debugging.
show ips stats Displays IP storage statistics.
show ips status Displays the IP storage status.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available