EasyManuals Logo

Cisco MDS 9000 Series Command Reference

Cisco MDS 9000 Series
1464 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #509 background imageLoading...
Page #509 background image
Send documentation comments to mdsfeedback-doc@cisco.com
8-45
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fcsp
The following example changes these three interfaces to initiate FC-SP authentication and permits
reaunthentication within two hours (120 minutes) of the initial authentication attempt.
switch(config-if)# fcsp auto-active 120
Related Commands Command Description
fcsp enable Enable FC-SP.
show interface Displays an interface configuration for a specified interface.

Table of Contents

Other manuals for Cisco MDS 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
CategorySwitch
Operating SystemCisco NX-OS
PortsVaries by model
ProtocolsFibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
RedundancyRedundant supervisors, power supplies, and fans
ManagementCisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization SupportVSANs (Virtual SANs)
Security FeaturesFibre Channel Security Protocol (FC-SP)
Hot Swappable Componentspower supplies, fans
Power Supply OptionsAC and DC options available

Related product manuals