Name: Cisco MDS 9000 Series
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Send documentation comments to mdsfeedback-doc@cisco.com

11-7

Cisco MDS 9000 Family Command Reference

OL-8413-07, Cisco MDS SAN-OS Release 3.x

Chapter 11 I Commands

install all

Usage Guidelines The install all command upgrades all modules in any Cisco MDS 9000 Family switch.

Tip During a software upgrade to Cisco MDS SAN-OS 3.1(3), all modules that are online are tested and the

installation stops if any modules are running with a faulty CompactFlash. When this occurs, the switch

can not be upgraded until the situation is corrected. A system message displays the module information

and indicates that you must issue the system health cf-crc-check module CLI command to

troubleshoot.

To copy a remote file, specify the entire remote path exactly as it is.

Caution If a switchover is required when you issue the install all command from a Telnet or SSH session, all

open sessions are terminated. If no switchover is required, the session remains unaffected. The software

issues a self-explanatory warning at this point and provides the option to continue or terminate the

installation.

See the Cisco MDS 9000 Family CLI Configuration Guide for detailed procedures.

Examples The following example displays the result of the install all command if the system and kickstart files are

specified locally.

switch# install all sys bootflash:isan-1.3.1 kickstart bootflash:boot-1.3.1

Verifying image bootflash:/boot-1.3.1