Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-31
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface gigabitethernet
The following example enters a IP address and subnet mask for the selected Gigabit Ethernet interface.
switch(config-if)# ip address 10.1.1.100 255.255.255.0
The following example changes the IP maximum transmission unit (MTU) value for the selected Gigabit
Ethernet interface.
switch(config-if)# switchport mtu 3000
The following example creates a VR ID for the selected Gigabit Ethernet interface, configures the virtual
IP address for the VR ID (VRRP group), and assigns a priority.
switch(config-if)# vrrp 100
switch(config-if-vrrp)# address 10.1.1.100
switch(config-if-vrrp)# priority 10
The following example adds the selected Gigabit Ethernet interface to a channel group. If the channel
group does not exist, it is created, and the port is shut down.
switch(config-if)# channel-group 10
gigabitethernet 4/1 added to port-channel 10 and disabled
please do the same operation on the switch at the other end of the port-channel, then do
“no shutdown” at both ends to bring them up
Related Commands Command Description
show interface Displays an interface configuration for a specified interface.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available