Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-83
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
iscsi dynamic initiator
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following command configures the dynamic initiator mode as iSLB.
switch(config)# iscsi dynamic initiator islb
The following command configures the dynamic initiator mode as deny.
switch(config)# iscsi dynamic initiator deny
The following command reverts to the default dynamic initiator mode of iSCSI.
switch(config)# no iscsi dynamic initiator deny
Related Commands Command Description
iscsi save-initiator Permanently saves the automatically-assigned nWWN or pWWN mapping.
show iscsi global Displays global iSCSI configured information.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available