Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
11-97
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
iscsi virtual-target name
The following command allows the specified iSCSI initiator node to access this virtual target. You can
issue this command multiple times to allow multiple initiators.
switch(config-iscsi-tgt)# initiator iqn.1987-02.com.cisco.initiator1 permit
The following command prevents the specified initiator node from accessing virtual targets.
switch(config-iscsi-tgt)# no initiator iqn.1987-02.com.cisco.initiator1 permit
The following command allows the specified IP address to access this virtual target:
switch(config-iscsi-tgt)# initiator ip-address 10.50.1.1 permit
The following command prevents the specified IP address from accessing virtual targets:
switch(config-iscsi-tgt)# no initiator ip-address 10.50.1.1 permit
The following command allows all initiators in this subnetwork to access this virtual target:
switch(config-iscsi-tgt)# initiator ip-address 10.50.0.0 255.255.255.0 permit
The following command prevents all initiators in this subnetwork from accessing virtual targets:
switch(config-iscsi-tgt)# no initiator ip-address 10.50.0.0 255.255.255.0 permit
The following command allows all initiator nodes to access this virtual target.
switch(config-iscsi-tgt)# all-initiator-permit
The following command prevents any initiator node from accessing virtual targets.
switch(config-iscsi-tgt)# no all-initiator-permit
The following command configures a primary and secondary port and moves the LUNs from one port to
the other using the trespass command.
switch# config terminal
switch(config)#iscsi virtual-target name iqn.1987-02.com.cisco.initiator
switch(config-iscsi-tgt)# pwwn 50:00:00:a1:94:cc secondary-pwwn 50:00:00:a1:97:ac
switch(config-iscsi-tgt)# trespass
Related Commands Command Description
show iscsi virtual target Displays information about iSCSI virtual targets.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available