Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
15-7
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 15 M Commands
member (fcalias configuration submode)
Command History
Usage Guidelines None.
Examples The following example shows how to add a member to an FC alias called samplealias.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcalias name samplealias
switch(config-fcalias)#
The following example defines an IPv6 address for the member.
switch(switch(config-fcalias)# member ip-address 2020:dbc0:80::4076
The following example shows how to delete the specified member.
switch(config-fcalias)# no member ip-address 2020:dbc0:80::4076
Related Commands
Release Modification
3.0(1) This command was introduced.
Command Description
fcalias name Configures an FC alias.
show fcalias Displays the member name information in an FC alias.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available