Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
18-8
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 18 P Commands
permit (IPv6-ACL configuration)
Examples The following example configures an IPv6-ACL called List, enters IPv6-ACL submode, and adds an
entry that permits IPv6 traffic from any source address to any destination address.
switch# config terminal
switch(config)# ipv6 access-list List1
sswitch(config-ipv6-acl)# permit tcp any any
The following example removes a permit condition set for any destination prefix on a specified UDP
host.
switch# config terminal
switch(config)# ipv6 access-list List1
switch(config-ipv6-acl)# no permit udp host 2001:db8:200d::4000 any
The following example removes the IPv6-ACL called List1 and all its entries.
switch# config terminal
switch(config)# no ipv6 access-list List1
Related Commands Command Description
ipv6 access-list Configures an IPv6 ACL and enters IPv6-ACL configuration submode.
deny Configures deny conditions for an IPv6 ACL.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available