Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-5
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
santap module
Command History
Usage Guidelines To access this command, you must first enable the SANTap feature on the SSM using the ssm enable
feature command.
When the lun-size-handling option is set (enabled), the maximum logical block addressing (LBA) for
DVT LUN is set to 2 TB. As a result, there is no issue with LUN resizing.
Note You can delete dvt target-pwwn using the no santap module slot dvt target-pwwn command. Other
dvt options are not supported by the no form of the command.
Examples The following example shows the configuration of the SSM where the SANTap feature is enabled and
the VSAN used to communicate with the appliance.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# santap module 1 appl-vsan 1
Related Commands
Release Modification
2.1(1a) This command was introduced.
3.0(1) Added the following options: cvt-name, dvt, target-pwwn, target-vsan,
dvt-name, dvt-vsan, dvt-port, lun-size-handling, and io-timeout.
Command Description
ssm enable feature Enables the SANTap feature on the SSM.
show santap module Displays the configuration and statistics of the SANTap feature.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available