Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-44
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
source
The following example shows how to configure the SPAN source interface as iSCSI interface 4/1.
switch(config-span)# source interface iscsi 4/1
The following example shows how to disable configure the SPAN source interface as FC 9/1 with an
egress filter for VSAN 1.
switch(config-span)# no source interface fc9/1 tx filter vsan 1
Related Commands Command Description
switchport Configures the switch port mode on the Fibre Channel interface.
span session Selects or configures the SPAN session and changes to SPAN
configuration submode.
destination interface Configures a SPAN destination interface.
suspend Suspends a SPAN session.
show span session Displays specific information about a SPAN session

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available