Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-79
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
system default switchport
The following example shows how to configure the trunk mode.
switch# config terminal
switch(config)# system default switchport trunkmode auto
The following example shows how to set the administrative mode of Fibre Channel ports to mode F.
switch# config terminal
switch(config)# system default switchport mode F
The following example shows how to set the administrative mode of Fibre Channel ports to the default.
switch# config terminal
switch(config)# no system default switchport mode F
Related Commands Command Description
show system default
switchport
Displays default values for switch port attributes.
show interface brief Displays FC port modes.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available