Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
21-96
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
system health module
switch(config)# system health module 6 bootflash failure-action
System health failure action for module 6 Bootflash test is already enabled.
The following example disables the bootflash test configuration.
switch(config)# no system health module 6 bootflash failure-action
System health failure action for module 6 Bootflash test is now disabled.
The following example sets the new frequency of the bootflash test to 200 seconds.
switch(config)# system health module 6 bootflash frequency 200
The new frequency is set at 200 Seconds.
The following example enables the EOBC test.
switch(config)# system health module 6 eobc
System health for module 6 EOBC is now enabled.
The following example enables the inband test.
switch(config)# system health module 6 inband
System health for module 6 EOBC is now enabled.
The following example enables the loopback test.
switch(config)# system health module 6 loopback
System health for module 6 EOBC is now enabled.
The following example enables the management test.
switch(config)# system health module 6 management
System health for module 6 EOBC is now enabled.
The following example shows how to set the CompactFlash CRC test interval.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system health module 6 cf-crc-check frequency 10
The following example shows how to set the CompactFlash CRC test failure-action feature.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system health module 6 cf-crc-check failure-action
The following example shows how to set the CompactFlash reflash update interval.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system health module 6 cf-reflash frequency 10
The following example shows how to set the CompactFlash reflash failure-action feature.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# system health module # cf-re-flash failure-action
Related Commands Command Description
show system health Displays system health information.
show system health
statistics
Displays system health statistics.

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available