Cisco Nexus 7000 Series - Page 800

ModificationRelease
Added the port-security keyword.4.0(3)
This command was introduced.4.0(1)
Usage Guidelines
You can use the command only in the default virtual device context (VDC).
This command does not require a license.
Examples
This example shows how to display all the hardware rate-limit configuration and statistics:
switch# show hardware rate-limiter
Units for Config: packets per second
Allowed, Dropped & Total: aggregated since last clear counters
Rate Limiter Class Parameters
------------------------------------------------------------
layer-3 mtu Config : 500
Allowed : 0
Dropped : 0
Total : 0
layer-3 ttl Config : 500
Allowed : 0
Dropped : 0
Total : 0
layer-3 control Config : 10000
Allowed : 0
Dropped : 0
Total : 0
layer-3 glean Config : 100
Allowed : 0
Dropped : 0
Total : 0
layer-3 multicast directly-connected Config : 3000
Allowed : 0
Dropped : 0
Total : 0
layer-3 multicast local-groups Config : 3000
Allowed : 0
Dropped : 0
Total : 0
layer-3 multicast rpf-leak Config : 500
Allowed : 0
Dropped : 0
Total : 0
layer-2 storm-control Config : Disabled
access-list-log Config : 100
Allowed : 0
Dropped : 0
Total : 0
copy Config : 30000
Allowed : 0
Dropped : 0
Total : 0
receive Config : 30000
Allowed : 0
Dropped : 0
Total : 0
layer-2 port-security Config : Disabled
layer-2 mcast-snooping Config : 10000
Allowed : 0
Dropped : 0
Total : 0
layer-2 vpc-low Config : 4000
Cisco Nexus 7000 Series Security Command Reference
774
Show Commands
show hardware rate-limiter