Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 262
Confidential
3.4.11.6 Magnet Latch
1. Remove the Color Measurement Device. (p255)
2. Remove the Mounter. (p132)
3. Remove the Upper Cover. (p257)
4. Remove the Right Cover. (p259)
5. Remove the Front Cover. (p261)
6. Remove the screw that secures the Housing, Lower, SPM.
A) Silver, Phillips, Round Washer Head S-tite M3x8: one piece
7. While lowering the Housing, Lower, SPM, slide the Housing, Front, Outer, SPM
in the direction of the arrow to remove it. (Housing, Front, Outer, SPM is secured
with the four dowels.)
Figure 3-203. Removing the Housing, Front, Outer, SPM
8. Remove the six screws that secure the Housing, Front, Inner, SPM.
B) Silver, Phillips, Round Washer Head S-tite M3x8: five pieces
C) Silver, Phillips, Bind P-tite M3x8: one piece
9. Remove the Housing, Front, Inner, SPM.
Figure 3-204. Removing the Housing, Front, Inner, SPM
A
Housing, Lower, SPM
Housing, Lower, SPM
Housing, Front, Outer, SPM
Dowels
C H E C K
P O I N T
In the next step, make sure to confirm which screw is attached to
which location because various screws are used here.
B
C
Magnet Latch
Housing, Front, Inner, SPM
To Next Page
Loading...
Need help?
General