115
────────────────────────────────────────────────────
7.3 STATUS Settings (REC&MEM)
────────────────────────────────────────────────────
Function
display Meaning
g-ent,LOG1, 2
:
Determines the data to load.
:
Cancel the command to load.
Flashing cursor
■
Loading Real-Time Save Data
To load data saved by Real-Time Save, load the index file (R_M). Data
loaded by the index file consists of all recorder waveforms and the header
(2000 DIV, or 10,000 DIV when expansion memory is installed) of the
memory waveform. Loading of the memory waveform is specified by use of
the A-B cursors within the recorder waveform. Refer to Section 14.8,
"Loading the Data (LOAD)" regarding loading data saved by Real-Time
Save.
When Real-Time Save is finished, the recorder waveforms remain in
memory, so it is not necessary to load the saved data.
Procedure
Screen: FILE
1. Press the FILE key to call up the FILE screen.
2. Move the flashing cursor to the media item, and use
the function key to select the "PC card" or "MO".
3. Use the jog and shuttle controls or cursor keys to
select the index file of the data to be loaded from the
file list.
4. Move the flashing cursor to the command item, and
use the function key to select the "LOAD".
5. Use the function keys to make selection.
■
Loading Memory Waveforms
The memory waveform is specified by use of the A-B cursors within the
recorder waveform.
Procedure
Screen: STATUS2
1. Press the DISP key to display the DISPLAY screen.
2. Move the blinking cursor to the location indicated in
the figure.
Press function key F4 (Record & Memory) to display
the recorder waveform screen (REC & mem).
To Next Page
Loading...
