Hioki 8841 - Page 28

4
────────────────────────────────────────────────────
1.2 Identification of Controls and Indicators
────────────────────────────────────────────────────
6
FILE key
Causes the display to show the FILE screen which serves for reading,
storing, etc. the waveform data etc.
7
PRINT key
Serves to print out stored waveforms.
Output destination can be set on the SYSTEM4 screen.
8
COPY key
Serves to print out a hard copy of the current screen display.
Copy destination can be set on the SYSTEM4 screen
9
FEED key
Causes the printer paper to advance for as long as the key is pressed.
10
VALUE key
Uses to select the numerical values setting.
11
WAVE key
Uses to select the the waveform scrolling.
12
A･BCSRkey
Uses to select the the A
･
B cursor moving.
13
Jog
Rotary control knob that serves to change values, move the A
･
B cursors,
and scroll the waveform.
14
Shuttle
Concentric ring that serves to change values, move the A
･
B cursors, and to
scroll the waveform. The speed of movement is proportional to the rotation
angle.
15
CURSOR key
These keys serve to move the flashing cursor in the four directions.
16
STOP key
Stops measurement and analysis.
Pressing this key twice stops measurement.
17
START key
Initiates the measurement and analysis. During measurement, the LED
above the key is lit.
18
TIME/DIV key
Serves to set the speed for inputting and storing the input signal.
19
MANU TRIG key
Serves to cause manual triggering.
20
CH.SET key
Sets the input channel on the display screen
Toggles the screen among those for analog channels (1 to 16) and logic
channels (A to D).
21
LEVEL MONl key
Serves to check the input signal level.
22
VIEW key
Serves to indicate the position of the currently displayed screen information
in relation to the entire recording length.
Call up information about the status of memory block.
23
AUTO key
Pressing this key activates automatic setting of time axis range and voltage
range values of input waveform.
24
HELP key
Provides on-line help.
25
F1 to F5 key
Serve to select setting items.
26
Channel select/
input value keys
Selects channel or sets numerical value
27
RANGE knob
Sets the measurement range for the channel.
28
POSITION knob
Sets the zero position for the channel.