APPENDIX 2
────────────────────────────────────────────────────
Appendix 1 Error Messages
────────────────────────────────────────────────────
Warning Message and explanation
WARNING 60: Insert MO disk.
No disk is present in the MO disk drive. Insert one.
WARNING 70: Insert Floppy disk.
No disk is present in the floppy disk drive. Insert one.
WARNING 71: Cannot load
(not 8841,42 data)
Data cannot be loaded, because it is not a set of data created
by the 8841/42.
WARNING 72: Illegal format.
The media is not a correctly formatted MS-DOS, or the
floppy disk is a 2DD, 640 KB format disk.
WARNING 73: Write Protected.
The media is write-protected. Release it.
WARNING 74: Disk full.
Data cannot be saved due to insufficient space on the storage
medium. Delete files, or use a new storage medium.
WARNING 75: File is read only.
File cannot be written or deleted, because it is read- only.
WARNING 76: General failure.
Access to disk is not possible because of some low-level
error, such as in formatting or file saving.
WARNING 80: Insert PC card.
No card is present in the PC card slot. Insert one.
WARNING 90: File already exists.
Another file of the same name exists. Saving cannot be
performed.
WARNING 91: Directory full.
Since only a limited number of files (including directory) can
be created in the root directory.
WARNING 92: Directory not empty.
The directory is not empty.
WARNING 93: Disk full.
Little capacity is available.
WARNING 94: Path name error.
Up to 127 characters can be used for a path name.
WARNING 95: Empty directory name.
Name the directory.
WARNING 96: Directory already exists.
Another directory of the same name exists. Saving cannot be
performed.
WARNING 97: 2DD type FD.
2DD-type FD Select the suitable format.
WARNING 98: 2HD type FD.
2HD-type FD Select the suitable format.
WARNING 99: Conditions for OVERWRITE
are not satisfied.
Match the unit condition and file data condition (function
and time-axis).
WARNING 201: Set printer paper.
Printer paper has run out. Reload.
WARNING 202: Set printer lever
The head up/down lever has been left in the up position.
WARNING 205: Invalid (START)
The key pressed is not valid, because measurement operation
is in progress.
WARNING 207: AUTO RANGE failure.
The auto ranging function has failed. Check the input signal.
WARNING 208: Cannot SAVE. (Write
Protected)
Remove the write-protect.
WARNING 209: Cannot SAVE. (Disk Full)
Little capacity is available.
WARNING 213: Invalid (MEASUREMENT)
Pressed key is invalid, because parameter processing is ON.
WARNING 214: Invalid. (Pre Trigger)
Additional recording set on, therefore pre-trigger can not be
set.
Warning Messages
・The "WARNING" indication is displayed on the bottom line of the screen,
followed by the message, but disappears after a few seconds.
・Warning messages also disappear if any key is pressed.
・If the "beep sound" item on the system screen is set to ON, then the beeper
sounds once only when the message is displayed.
To Next Page
Loading...
