Send documentation comments to mdsfeedback-doc@cisco.com
22-290
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show santap module
The following example displays the SANTap configuration session.
switch# show santap module 2 session
Session Information :
session id = 1
host pwwn = 21:00:00:e0:8b:07:61:aa
dvt pwwn = 22:00:00:20:37:88:20:ef
dvt lun = 0x0
tgt pwwn = 00:00:00:00:00:00:00:00
tgt lun = 0x0
adt pwwn = 77:77:77:77:77:77:77:77
adt lun = 0x0
num ranges = 0
dvt id = 0
vdisk id = 0
session state = 0
mrl requested = 1
pwl requested = 1
iol requested = 0
The following example displays the SANTap RVT configuration.
switch# show santap module 2 rvt
RVT Information :
rvt pwwn = 2a:61:00:05:30:00:22:25
rvt nwwn = 2a:62:00:05:30:00:22:25
rvt id = 17
rvt vsan = 4
rvt if_index = 0x1080000
The following example displays the SANTap RVTLUN configuration.
switch# show santap module 2 rvtlun
RVT LUN Information :
rvt pwwn = 2a:61:00:05:30:00:22:25
rvt lun = 0x0
xmap id = 22
rvt id = 17
app pwwn = 22:00:00:20:37:39:b1:00
app lun = 0x0
app vsan = 1
The following example displays information for technical support.
switch# show santap module 4 tech-support
DVT Information :
dvt pwwn = 22:00:00:20:37:39:b1:00
dvt nwwn = 20:00:00:20:37:39:b1:00
dvt id = 0x83fe924
dvt mode = 3
dvt vsan = 1
dvt if_index = 0x1180000
dvt fp_port = 1
dvt name = MYDVT3
dvt tgt-vsan = 2
dvt io timeout = 10 secs
dvt lun size handling = 1
dvt app iofail behaviour = 0
dvt quiesce behavior = 0
dvt tgt iofail behavior = 0
dvt appio failover time = 0 secs
To Next Page
Loading...
Need help?
General
