Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-324
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show system
Examples The following example displays the system redundancy status.
switch# show system redundancy status
Redundancy mode
---------------
administrative: HA
operational: None
This supervisor (sup-2)
-----------------------
Redundancy state: Active
Supervisor state: Active
Internal state: Active with no standby
Other supervisor (sup-1)
------------------------
Redundancy state: Not present
The following example displays port states after the system default switchport mode f command is
executed.
switch# show system default switchport
System default port state is down
System default trunk mode is on
System default port mode is F
The following example displays error information for a specified ID.
switch# show system error-id 0x401D0019
Error Facility: module
Error Description: Failed to stop Linecard Async Notification.
The following example displays the system health information.
switch# show system health
Current health information for module 2.
Test Frequency Status Action
-----------------------------------------------------------------
Bootflash 10 Sec Enabled Enabled
EOBC 5 Sec Enabled Enabled
Loopback 5 Sec Enabled Enabled
CF checksum 7 Sec Enabled Enabled
CF re-flash 30 Sec Enabled Enabled
-----------------------------------------------------------------
Current health information for module 3.
Test Frequency Status Action
-----------------------------------------------------------------
Bootflash 10 Sec Enabled Enabled
EOBC 5 Sec Enabled Enabled
Loopback 5 Sec Enabled Enabled
-----------------------------------------------------------------
Current health information for module 5.
Test Frequency Status Action
-----------------------------------------------------------------
InBand 5 Sec Enabled Enabled
Bootflash 10 Sec Enabled Enabled
EOBC 5 Sec Enabled Enabled
Management Port 5 Sec Enabled Enabled
CF checksum 7 Sec Halted Enabled

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available