Send documentation comments to mdsfeedback-doc@cisco.com
22-325
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show system
CF re-flash 30 Sec Halted Enabled
-----------------------------------------------------------------
The following example displays the system reset information.
switch# show system reset reason
----- reset reason for module 6 -----
1) At 520267 usecs after Tue Aug 5 16:06:24 1980
Reason: Reset Requested by CLI command reload
Service:
Version: 1.2(0.73a)
2) At 653268 usecs after Tue Aug 5 15:35:24 1980
Reason: Reset Requested by CLI command reload
Service:
Version: 1.2(0.45c)
3) No time
Reason: Unknown
Service:
Version: 1.2(0.45c)
4) At 415855 usecs after Sat Aug 2 22:42:43 1980
Reason: Power down triggered due to major temperature alarm
Service:
Version: 1.2(0.45c)
The following example displays system-related CPU and memory statistics.
switch# show system resources
Load average: 1 minute: 0.43 5 minutes: 0.17 15 minutes: 0.11
Processes : 100 total, 2 running
CPU states : 0.0% user, 0.0% kernel, 100.0% idle
Memory usage: 1027628K total, 313424K used, 714204K free
3620K buffers, 22278K cache
The following example displays the system uptime.
switch# show system uptime
Start Time: Sun Oct 13 18:09:23 2030
Up Time: 0 days, 9 hours, 46 minutes, 26 seconds
Use the show system cores command to display the currently configured scheme for copying cores.
switch# show system cores
Transfer of cores is enabled
Use the show system default zone command to display the default values for a zone.
switch# show system default zone
system default zone default-zone permit
system default zone distribute active only
To Next Page
Loading...
Need help?
General
