Send documentation comments to mdsfeedback-doc@cisco.com
xxxviii
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
New and Changed Information
New and Changed Commands for Cisco SAN-OS Release 3.1(1)
Nondisruptive software
upgrades
clear install failure-reason command C Commands
show install all failure-reason command
show install all status command
show install all impact command
Show Commands
On-demand port activation port-license command P Commands
show port-license command Show Commands
Removal of oversubscription
ratio restrictions
rate-mode oversubscription-limit command R Commands
IP Network Simulator ips netsim enable command
ips netsim max-bandwidth-kbps command
ips netsim qsize command
ips netsim delay-ms command
ips netsim drop nth command
ips netsim reorder command
I Commands
show ips netsim command
show ips stats fabric interface command
Show Commands
Technical support show tech-support command (device-alias
option)
Show Commands
Cisco MDS 9124 Multilayer
Fabric Switch support
The following commands were updated to
indicate that they are not supported on the
Cisco MDS 9124 Fabric Switch:
cloud-discovery enable command
crypto ike enable command
crypto ipsec enable command
fcc enable command
fcip enable command
fcrxbbcredit extended enable command
fc-tunnel command
ficon enable
iscsi enable command
ivr enable command
san-ext-tuner enable command
zone broadcast enable vsan command
C Commands
F Commands
I Commands
S Commands
Z Commands
Table 1 New and Changed Commands in the Cisco MDS 9000 Family Command Reference (continued)
Feature Description Where Documented
To Next Page
Loading...
Need help?
General
