Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
xliii
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
New and Changed Information
FICON Port Numbering ficon enable command
ficon logical-port assign port-numbers
command
ficon slot assign port-numbers command
ficon swap command (interface option)
F Commands
show ficon command (port-numbers and stat
options; pib and portnumber keywords)
Show Commands
Generation 2 Module Support channel-group command C Commands
debug port-resources command Debug Commands
out-of-service command O Commands
switchport command (fcbbscn option, ST
option to mode keyword, 4000 option to
speed keyword, auto max 2000 option to
speed keyword, rate-mode keyword; added
Gigabit Ethernet interface syntax and
management interface syntax)
S Commands
show interface command (fc capabilities
option)
show module command (recovery-steps and
x-bar options)
show npv flogi-table command
show port-resources module command
Show Commands
IKE Enhancements authentication command A Commands
identity command I Commands
keycommand(hostname keyword) K Commands
Table 1 New and Changed Commands in the Cisco MDS 9000 Family Command Reference (continued)
Feature Description Where Documented

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available