Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
xliv
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
New and Changed Information
IPv6 clear ips stats command
clear ips stats fabric interface command
clear ipv6 neighbors command
clear vrrp command (ipv4 and ipv6 options)
C Commands
deny (IPv6-ACL configuration) command D Commands
ipv6 access-list command
ipv6 address command
ipv6 address autoconfig command
ipv6 enable command
ipv6 nd command
ipv6 route command
ipv6 routing command
ipv6 traffic-filter command
I Commands
permit (IPv6-ACL configuration) command
ping command(ipv6 option)
P Commands
show ip arp command
show ip interface command
show ip traffic command
show ips ipv6 command
show ipv6 access-list command
show ipv6 interface command
show ipv6 neighbours command
show ipv6 route command
show ipv6 routing command
show ipv6 traffic command
show vrrp command (ipv6 option)
Show Commands
traceroute command (ipv6 option) T Commands
vrrp command(ipv6 option; address and
advertisement-interval options specific to
IPv6)
V Commands
iSCSI Server Load Balancing
(iSLB)
clear islb session command C Commands
debug ips command (iSLB and iSNS options) Debug Commands
Table 1 New and Changed Commands in the Cisco MDS 9000 Family Command Reference (continued)
Feature Description Where Documented

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available