Cisco MDS 9000 Series

Send documentation comments to mdsfeedback-doc@cisco.com
22-20
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show cdp
The following example displays CDP parameters for the management interface.
switch# show cdp interface mgmt 0
mgmt0 is up
CDP enabled on interface
Sending CDP packets every 60 seconds
Holdtime is 180 seconds
The following example displays CDP parameters for the Gigabit Ethernet interface.
switch# show cdp interface gigabitethernet 4/1
GigabitEthernet4/1 is up
CDP enabled on interface
Sending CDP packets every 80 seconds
Holdtime is 200 seconds
The following example displays CDP Neighbors (brief).
switch# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Hldtme Capability Platform Port ID
0 Gig4/1 135 H DS-X9530-SF1- Gig4/1
069038732(Kiowa2 mgmt0 132 T S WS-C5500 8/11
069038747(Kiowa3 mgmt0 156 T S WS-C5500 6/20
069038747(Kiowa3 mgmt0 158 T S WS-C5500 5/22
The following example displays CDP neighbors (detail).
switch# show CDP neighbor detail
----------------------------------------
Device ID:Switch
System Name:
Interface address(es):
Platform: cisco WS-C2950T-24, Capabilities: Switch IGMP Filtering
Interface: mgmt0, Port ID (outgoing port): FastEthernet0/24
Holdtime: 137 sec
Version:
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(19)EA1c, RELEASE SOFTWARE
(fc2)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Mon 02-Feb-04 23:29 by yenanh
Advertisement Version: 2
Native VLAN: 1
Duplex: full