SHOP MANUAL
Engine
Ch 1 page 86
1. Unscrew the filter cover with a closed tool with 36 mm
socket.
2. Lift out the filter housing cover with filter. The filter housing
will drain automatically once the filter has been removed.
3. Remove old filter from the cover.
4. Assemble new filter and tighten filter cover to 25 Nm.
Changing oil filter
Clean the centrifugal oil cleaner when renewing the oil lter.
Otherwise, the oil lter will be blocked and resistance in the
lter will increase. If this happens, an overow valve in the lter
holder opens and lets the oil pass without being ltered.
Do not use an adjustable wrench or other open tool as there is
risk of damaging the lter cover.
NOTE
Only use a DOOSAN oil lter.
NOTE
NOTE
Remember that oil splashes.
CAUTION
Figure 164
Figure 165
To Next Page
Loading...