SHOP MANUAL
HYDRAULIC
Ch 5 page 26 Ch 5 page 27
HYDRAULIC
Main pump pressure adjusting
Low Pressure Adjustment:
Connect the manometer at the test port P1M (140)
on the Test Block.
Engine idle, pressure 20 bar.
Adjust the pump to the correct value 20 bar:
• Loosening the nut and turning the screw clockwise
you will increase pressure
• Loosening the nut and turning the screw counter-
clockwise you will decrease pressure
• Be sure to lock the nut after adjustments.
Low pressure
20 bar
Figure 10
Figure 11
To Next Page
Loading...