EasyManua.ls Logo

Doosan DA40 - Fuel Heater; A;C compressor control

Doosan DA40
945 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SHOP MANUAL
Ch 6 page 48
ELECTRICAL SYSTEM
Fuel Heater
A/C compressor control
The fuel heater is enabled with a button on the switch panel.
The fuel heater is located inside the diesel filter on the engine. The
heater also has an integrated thermostat that will switch off at ap-
prox. 25°C to not overheat the diesel fluid.
The A/C clutch is controlled by the VCU2. There are two pressure transmitters connected in the A/C system
together with the A/C request from the climate control panel to control the clutch.
To enable clutch the following conditions must be met:
Request signal from control panel = ACTIVE
LP pressure between 0.3/0.4 to 19/22bar
HP pressure between 1.8/2.0 to 19/22bar
To extend compressor lifetime the minimum off time is set to 15 seconds.
Figure 26

Table of Contents