EasyManua.ls Logo

Doosan DA40 - Product final inspection

Doosan DA40
945 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ch 6 page 27
ELECTRICAL SYSTEM
SHOP MANUAL
Product final inspection
The following controls are performed on each unit before leaving SNDC.
1)HEATER CONTROL
• Tightness test
• Water valve operation (opening/closing)
2)AIR CONDITIONING CONTROL
• Tightness test
• Thermostat connection
3)ELECTRICAL FUNCTIONS
• Control panel backlight
• Control panel display
• Fresh air door operation (opening/closing)
• Amperage when blower is operating at full speed
• Outside temperature measurement
• Inside temperature measurement
• Electrical continuity
• Low and high pressure switches connexion

Table of Contents