SHOP MANUAL
Engine
Ch 1 page 188
6. Disassemble the Air Condition hose clamp and the condenser
at the front from cooling pack.
Place the condenser and the dryer filter on the left side of the
engine.
7. Fastening the lifting device to the radiator unit.
Check that all cooling pipes and hoses are disassembled
8. Disassemble the upper bracket between engine and fan brack-
et,
(3 screws).
Place the expansion tank on the engine
9. Disassemble lower fastening 2 screws
(left and right hand side)
10. Check again that all wiring and hoses are disassembled.
Carefully lift the cooler unit out from the frame.
Do not disassemble the Air Condition hoses from the con-
denser lter or the compressor.
NOTE
Figure 364
Figure 365
Figure 366
To Next Page
Loading...