SHOP MANUAL
TRANSMISSION
Ch 2 page 54 Ch 2 page 55
TRANSMISSION
Mount output flange (1) until contact is obtained and insert O-
ring 69x3 (2) into the space between output flange and shaft.
Fix output flange (1) with disk (2) and hexagon screws (3).
Oil the hexagon screws prior to assembly.
Tightening torque (M12/10.9x65) MA = 120 Nm
ALWAYS fit new hexagon screws!
Before putting the transmission into operation, ll it
with oil (For uid type and specications, refer to the
DOOSAN Operating & Maintenance Manual Chapter 6) /
Order No.4662 700 017!
Check oil level with dipstick located on hydraulic tank and make
sure correct amount is filled.
CAUTION
Figure 131
Figure 130
Figure 132
To Next Page
Loading...