SHOP MANUAL
DRIVE LINE
Ch 3 page 62 Ch 3 page 63
DRIVE LINE
5.
Remove the stabilizer bar cotter pin and retainer pin.
Hinge the stabilizer bar so it is out of the way.
Figure 172.
6.
Lift the inner lining out of the caliper
assembly. If you plan to reuse the lining,
mark the lining INBOARD.
7.
Slide the caliper OUTWARD and remove the
outboard lining. If you plan to reuse the
lining, mark the lining OUTBOARD.
8.
Verify that the caliper slides freely on the
slide pins.
9.
Remove dirt and dust from the lining contact
surfaces of the saddle.
10.
Inspect the caliper boots. If the boots are
damaged, replace the caliper/saddle
assembly.
11.
Inspect the disc for wear and damage.
Refer to Section 5.
If the caliper moves past its working position and
jams on the slide pins, use a rubber mallet to move
the caliper back to its working range.
NOTE
Figure 172
To Next Page
Loading...