Hioki 8841 - Page 9

Chapter 12 SYSTEM Screen Settings 259
12.1 Overview 259
12.2 SET UP Screen (SYSTEM 1)
260
12.2.1 Using Channel (MEM only) 260
12.2.2 Start Backup
261
12.2.3 Backlight Saver
261
12.2.4 Display Color
262
12.2.5 Beep Sound
262
12.2.6 Display Language 263
12.2.7 Grid Type 263
12.2.8 Channel Marker 263
12.2.9 Time Value
264
12.2.10 List & Gauge
264
12.2.11 Printer Density 264
12.2.12 Upper-lower Values Print 264
12.2.13 0 Position Comment 265
12.2.14 Counter Print
265
12.2.15 Numerical Input
265
12.2.16 Variable Auto Calibration 266
12.3 SCALING Screen (SYSTEM 2) 266
12.4 COMMENT Screen (SYSTEM 3)
267
12.5 INTERFACE Screen (SYSTEM 4)
268
12.5.1 Output Destination by the COPY Key 269
12.5.2 Output Destination by the PRINT Key 269
12.5.3 Interface Settings 269
12.5.4 Setting the SCSI ID 270
12.5.5 Setting the Internal MO (when the 9607 is
installed) 270
12.5.6 Setting the LAN 271
12.6 INITIALIZE Screen 278
12.6.1 Setting the Clock 278
12.6.2 Clearing the Waveform Data 278
12.6.3 System Reset 279
12.6.4 List System Configuration 279
12.7 Self-check 280
12.7.1 ROM/RAM Check 280
12.7.2 Printer Check
280
12.7.3 Display Check 281
12.7.4 Key Check 281
12.7.5 PC Card Check 281