Chapter 7. Administration - Enterprise 127
Draft Document for Review August 30, 2007 12:59 am 7065Admin_Enterprise.fm
Figure 7-13 Configure Alerts - SNMP
Rename
If you multiple DS3000’s installed, we recommend giving each one a user-specified name for
easier identification. To rename a DS3000, choose this option, enter a new name for the
subsystem and click OK. (Figure 7-14)
Figure 7-14 Rename Storage Subsystem
Note: An SNMP manager is required to receive and translate your SNMP traps, for
example, IBM Director. For more information about IBM Director and how to configure it,
see Implementing IBM Director 5.20, SG24-6188.
Note: We recommend you set the name only during the initial setup of the box, and do not
change it later. Some operating systems use the storage subsystem name for
identification.
To Next Page
Loading...
Need help?
General