Chapter 18. iSCSI configuration 3 - Windows 2003 Cluster 435
Draft Document for Review August 30, 2007 12:59 am 7065iSCSI_Config3.fm
Figure 18-59 Add nodes wizard complete
12.The Cluster Administrator in Figure 18-60 shows that the cluster is now running with two
cluster nodes.
Figure 18-60 Cluster with both nodes running
The cluster is now running with the default network usage. We will configure this now for our
requirements.
18.12 Configure the cluster network usage
By default all networks found during the cluster installation are used for internal and client
communication. One network must be configured for internal communication only. To have
redundant internal network communication it is possible to run internal and client
communication on the same network. This section describes the setup of the network usage
To Next Page
Loading...
Need help?
General