7065iSCSI_Config3.fm Draft Document for Review August 30, 2007 12:59 am
430 IBM System Storage DS3000: Introduction and Implementation Guide
Figure 18-48 Finish server cluster wizard
12.Now the Cluster Administrator is visible, showing a connection to the newly created
cluster. The cluster contains our node Mara, as in Figure 18-49.
Figure 18-49 Single node cluster on host MARA
Now we will install the cluster service on the remaining nodes of the cluster.
18.11 Install cluster service on the remaining nodes
The cluster currently contains only the first node only. Now we need to install the cluster
service on the remaining nodes - Ora in our configuration. This action can be done from a
management station where a Cluster Administrator is available, from the first node or any
other node. This section uses the first node to install the cluster service on the remaining
nodes.
1. Use the running Cluster Administrator on the first node. Click File → Open Connection.
In the Open Connection to Cluster dialog select Add nodes to cluster from the Action
To Next Page
Loading...
Need help?
General