Chapter 19. FC configuration 1 - Emulex HBA boot BladeServer from SAN 447
Draft Document for Review August 30, 2007 12:59 am 7065FC_Config1.fm
Figure 19-8 Zone created
5. After adding the zone members, the view should look similar to Figure 19-9.
Figure 19-9 Members added to zone
6. Save the new zoning - click Apply and the “Save Zoning & Error Check” window will
appear (Figure 19-10 on page 448). Click Perform Error Check and if no errors are found
click Save Zoning.
To Next Page
Loading...
Need help?
General