Chapter 11. Administration - Tools 247
Draft Document for Review August 30, 2007 12:59 am 7065Admin_Tools.fm
11.2 Storage array
The Storage array section of the Tool s tab includes the following wizards:
Rename Storage Subsystem
Set or Change Password
Change Media Scan Settings
Locate >>
View / Enable Premium Features
Change Enclosure ID Numbers
11.2.1 Rename Storage Subsystem
If you have several storage subsystems installed in your environment, you should give each
subsystem a meaningful name, so that you can distinguish between the systems. When you
first add the storage subsystem to your Storage Manager it is identified as “Unnamed”. You
can assign a name to it during the initial setup ( 4.4.2, “Rename the storage subsystem” on
page 62), or later using this option.
If you are not sure of which name is assigned to a specific storage subsystem, see 4.4.1,
“Locate the storage subsystem” on page 61 or “Locate Storage Subsystem or Enclosures” on
page 254 for instructions.
Rules of naming
Use these rules when assigning names to your disk subsystems:
Names can contain a maximum of 30 characters
Names can include letters, numbers, and the special characters underscore (_), minus (-),
and pound sign (#). No other special characters are permitted.
Use a clear meaningful name that is easy to understand and to remember. Avoid arbitrary
names or names that lose their meaning in the future.
Rename Subsystem - Step by Step
1. Click Rename Storage Subsystem (Figure 11-1 on page 246) to open the associated
view (Figure 11-2).
To Next Page
Loading...
Need help?
General