IBM DS3000

7065FC_Config2.fm Draft Document for Review August 30, 2007 12:59 am
482 IBM System Storage DS3000: Introduction and Implementation Guide
set hostPort [PaSak_Port0] hostType="Windows 2000/Server 2003 Clustered";
set hostPort [PaSak_Port1] hostType="Windows 2000/Server 2003 Clustered";
show "Add hosts to host group";
set Host [Yom] hostGroup="Thailand_Cluster";
set Host [PaSak] hostGroup="Thailand_Cluster";
show "Creating Logical Drive Quorum on existing Array 1.";
create LogicalDrive array=1 userLabel="Quorum" owner=A segmentSize=128 capacity=1
GB;
show "Setting additional attributes for Logical Drive Quorum.";
// Configuration settings that can not be set during Logical Drive creation.
set logicaldrive["Quorum"] cacheFlushModifier=10;
set logicaldrive["Quorum"] cacheWithoutBatteryEnabled=false;
set logicaldrive["Quorum"] mirrorEnabled=true;
set logicaldrive["Quorum"] readCacheEnabled=true;
set logicaldrive["Quorum"] writeCacheEnabled=true;
set logicaldrive["Quorum"] mediaScanEnabled=true;
set logicaldrive["Quorum"] redundancyCheckEnabled=false;
set logicaldrive["Quorum"] readAheadMultiplier=1;
set logicaldrive["Quorum"] modificationPriority=high;
show "Map logical drives to the host group";
set logicalDrive ["Quorum"] logicalUnitNumber=0 hostGroup="Thailand_Cluster";
remove logicalDrives [PaSak_Raid5] lunMapping;
set logicalDrive ["PaSak_Raid5"] logicalUnitNumber=2 hostGroup="Thailand_Cluster";
remove logicalDrives [PaSak_Raid1] lunMapping;
set logicalDrive ["PaSak_Raid1"] logicalUnitNumber=1 hostGroup="Thailand_Cluster";
show "Rename logical drive that it fits to the cluster naming";
set logicalDrive ["PaSak_Raid1"] userLabel="Thailand_Cl_Raid1";
set logicalDrive ["PaSak_Raid5"] userLabel="Thailand_ClRaid5";
20.3.3 Enable the Cluster Service
Open the disk management of your first cluster node and create a NTFS filesystem on the
newly generated Quorum Logical drive. Assign drive letter Q to this drive. The required steps
are shown in Chapter 20.2.3, “Windows Disk Manager” on page 474.
Initiating the Cluster Wizard
1. To imitate the Cluster Wizard, click Start → Run → type cluadmin.
2. From the Action menu select Create new cluster and click OK(Figure 20-23 on
page 482).
Figure 20-23 Create new Cluster