7065Admin_Modify.fm Draft Document for Review August 30, 2007 12:59 am
240 IBM System Storage DS3000: Introduction and Implementation Guide
Figure 10-41 Volume Copy - Change Priority
Review the information, set a new priority and click OK. When the priority change is done you
have you will be informed(Figure 10-42). Click OK to accept it.
Figure 10-42 VolumeCopy - Priority Change Complete
Remove copy pairs
Use this option to remove one or more logical drive copies from Copy Manager. After the
VolumeCopy is removed from Copy Manager, the target logical drive can be selected as a
source logical drive or target logical drive for a new VolumeCopy.
If you remove a VolumeCopy, the source logical drive and target logical drive are no longer
displayed in Copy Manager.
The procedure for removing VolumeCopy pairs is as follows:
1. Highlight the copy pair and click Remove. The Remove Copy Pairs window
appears.(Figure 10-43). Read the information and click Yes.
Important: Consider the following information:
This option does not delete the data on the source logical drive or target logical drive.
If the VolumeCopy has a status of In Progress, it must be stopped before you can
remove the copy pair from the Copy Manager.
To Next Page
Loading...
Need help?
General