7065iSCSI_Config3.fm Draft Document for Review August 30, 2007 12:59 am
406 IBM System Storage DS3000: Introduction and Implementation Guide
3. Join both nodes to the same Windows domain. It is not supported to have Active Directory
installed on the cluster nodes - a non-clustered node is required. The domain membership
is used to provide a domain account available for the cluster service account on all nodes.
That is the account under which the cluster service will operate.
4. Create a domain account to be used later on the cluster nodes to run the cluster service.
There are no special requirements for this account - all necessary rights will be granted to
this account when the cluster service is setup on the first node.
5. Download the Microsoft Software initiator from
http://www.microsoft.com/downloads/details.aspx?FamilyID=12cb3c1a-15d6-4585-b38
5-befd1319f825&DisplayLang=en. The User guide and release notes can be found in the
same location.
18.4 Install iSCSI software initiator
Install the Microsoft Software initiator onto each node.
1. Run the installer package downloaded for your platform during preparation. Figure 18-2
shows an example package.
Figure 18-2 iSCSI software initiator install package
2. On the Welcome screen, Figure 18-3, click Next.
Figure 18-3 Software update installation wizard
3. Select Initiator Service and Software Initiator. See Figure 18-4.
To Next Page
Loading...
Need help?
General