Chapter 16. iSCSI configuration 1 - Windows 2003 with QLogic QMC4052 HBA 343
Draft Document for Review August 30, 2007 12:59 am 7065iSCSI_Config1.fm
16.2 Install Windows Server 2003
Follow the operating system installation instructions that are available for each IBM
BladeCenter blade and System x server. The installation guides can be found in the
“Install/use” section of each product’s support web sites.
For our IBM BladeCenter HS21 (8853) with Microsoft Windows Server 2003, we used the
instructions shown in
http://www-304.ibm.com/jct01004c/systems/support/supportsite.wss/docdisplay?lndoci
d=MIGR-66309&brandind=5000020.
16.3 Install the iSCSI HBA driver
The Microsoft Windows Server 2003 installed does not include the device drive for the QLogic
iSCSI HBA. In this section we will show how to install this driver.
iSCSI HBA 1 - NIC
Port 0
172.16.200.62/16
iSCSI HBA 1 - NIC
Port 1
172.17.200.62/16
iSCSI HBA 1 -iSCSI
Port 0
172.16.200.63/16
iSCSI HBA 1 -iSCSI
Port 1
172.17.200.63/16
System Storage
DS3300
Controller A - Mgt. 172.18.3.1/16 Management LAN
Controller A - iSCSI
Port 1
172.16.3.1/16 iSCSI LAN 1
Controller A - iSCSI
Port 2
172.17.3.1/16 iSCSI LAN 2
Controller B - Mgt. 172.18.3.2/16 Management LAN
Controller B- iSCSI
Port 1
172.16.3.2/16 iSCSI LAN 1
Controller B - iSCSI
Port 2
172.17.3.2/16 iSCSI LAN 2
iSNS Service IP 172.18.0.9/16 Management LAN
Device Description Value Comments
To Next Page
Loading...
Need help?
General