7065DS3KBasicConfig.fm Draft Document for Review August 30, 2007 12:59 am
44 IBM System Storage DS3000: Introduction and Implementation Guide
Figure 4-1 Sample hardware setup
The Initial Setup Tasks wizard is designed for quick and easy DS3000 installation. This
wizard contains the essential steps required to get your DS3000 up and running. The tasks
available through the wizard are:
1. Locate the storage subsystem
2. Rename the storage subsystem
3. Set a storage subsystem password
4. Configure host access
5. Configure storage subsystem (automatic or manual creation of arrays and logical drives)
6. (Optional) View and enable premium features
7. (Optional) Change network configuration
We will describe the Initial Setup Tasks wizard in 4.4, “Initial Setup Tasks wizard” on page 60.
Note: In this chapter we focus mainly on the functions provided by the wizard. This
wizard tries to automate functions where possible. However, experienced users will
want to know how to perform these same functions manually - therefore you can
consider this chapter to be a “Quick Start” - more detailed information on these
functions is in Part 3, “Administration” on page 115.
System x 3755
SAN switch
DS3400
EXP3000
To Next Page
Loading...
Need help?
General